PIR-001 polyimide resin

Polyimide Resin Powder is synthetic polymerized resin,and smashed into fine powder by airflow. It has excellent heat stability, mechanical and dielectric strength, radiation and chemical resistance,etc., widely used from automotive industry and aerospace to industrial applications and office machines.

Characters:

* Excellent heat resistance. * Excellent dielectric performance. *Higher mechanical strength, better tear resistance and flexibility.

*Machinable with standard tools * Low wear and friction * Good compatibility with fillers

Product type: PIR-001 BMI-based polyimide     click to Download data sheet

Application: used as solid lubricants in grinding wheels of diamond,CNB,etc. and matrix resin for composite materials.

Packing: carton or drum after sealed by plastic film bag  net weight:20kgs/carton Shelf life: 2 Years

Properties( The follows are just examples not read as guaranteed values)

Visual/Solubility

Fine yellow powder/soluble in DMF,NMP,etc.

Purity%

Over 98.5

Gravity

1.32g/cm3

Particle size

30-40um (customized sizes also available)

Curing temperature()/Pressure(MPa)

220-230/30-60

Softening temperature

90-120

Martin temperature

260

TGA26024hr/30024hr

Less 1.5% (mainly moisture loss)

Tg

330

Tensile strength(MPa)

113.4

Elongation%

Over 5%

Flexural Strength(MPa)

160

Flexural Modulus(MPa)

3500

Compressive strength 10% strain (MPa)

150

Impact Strength unnotched KJ/m²

65

Surface resistivity

1 x 1015

Dieletric consistant

3.5

Reference work process for polyimide resin powder in grinding wheels:

Recommended curing temperature: around 230℃;Recommended heat pressure: 30-60MPa

        1.When mould temperature reaches around 160-170℃,start gas emission for 3-5times. Emission time depends on real situation of final users. Curing time can

          also be increased or decreased based on real situation of final users.

        2.For primer coating,the primer solution should be applied thinly to the roughened bonding surface (using a brush) and dried for about 10 hours at 250 °C.

        3.For release agent,we recommend silicone oil spray to be applied in a very thin coating on the mould surfaces

 4.With regarding to fillings for polyimide resin diamond grinding wheel, relies on end users.

Note:1.polyimide resins are hygroscopic, please predried at 250 °F (120 °C) for a couple of hours before any use

       2.All of above information is based on our best knowledge, not read as guarantees. Right reserved for corrections.

3.Please contact us if customization requirements